Accurate, tough and economic gauges for permanent
installation across air system filters to indicate necessary cleaning
or replacement
Manufactured from solid acrylic block with
high accuracy drillings that give an indicating column of good resolution.
An overpressure chamber is included to help prevent fluid loss.
The units are supplied as a complete kit of gauge, fixing screws,
tubing, filling funnel and duct connectors.
Wide range of models available
(Refer to the table below)
.
Two inclined models (ST1 .5 and
ST4) of the same physical dimensions are available. The ST4 is filled
with a heavy inert fluid SG 1.99 to give a compact inclined gauge
with a higher pressure range. An alternative is the ST4B, which is
an upright model covering the same pressure range but using standard
SG 0.8 red fluid rather than the relatively expensive SG 1.99.
Models are dual scaled, inches water
gauge and pascals to avoid unnecessary scale changes.
For easy zero
adjustment the reservoir seal can be screwed in or out to align the
fluid column with the scale zero mark. Gauges are supplied ready filled.
Although very competitively priced, these
gauges are more robust and of higher quality than many other instruments
used in this application.
For quantities of 50 and above, customer logos
can be incorporated. Integral spirit bubble option also available.
Model
Range
Fluid
Size (height x width x thickness)
ST0.8 (inclined)
0-200 Pa/0.8 IN WG
SG0.8
100 x 200 x 25mm
ST1.5 (inclined)
0-375 Pa/1.5 IN WG
SG 0.8
95 x 200 x l5mm
ST4 (inclined)
0-1000 Pa/4 IN WG
SG 1.99
95 x 200 x l5mm
ST4B (upright)
0-1000 Pa/4 IN WG
SG 0.8
200 x 50 x 25mm
ST2 (inclined)
0-500 Pa/2 IN WG
SG 0.8
110 x 200 x 15mm
ST2.5 (upright)
0-625 Pa/2.5 IN WG
SG 0.8
150 x 50 x 15mm
ST8 (upright)
0-2000 Pa/8 IN WG
SG 0.8
350 x 500 x 25mm
Rear or angled connectors can be incorporated
where panel mounting is required.
In addition to the standard instruments
listed above we produce special units to meet specific customer
requirements.
Some examples are: Very low range gauges e.g. 0-50 Pa with built-in
spirit level for clean room applications.
website
design by:
Poddymeter Limited Unit 2, Park Works, Borough Road, Kingston
upon Thames, Surrey KT2 6BD, United Kingdom Tel: 020 8546 9311 Fax: 020 8547 2325
www.poddymeter.co.uk E-MAIL: